Hellvape Dead Rabbit M RTA is a flavor and vapor-focused RTA atomizer that combines the fast and balanced heating characteristics of mesh coil technology with a rebuildable tank structure.
The clamp-style build deck makes it easy to secure mesh sheets, while the spring-loaded ceramic cotton bed helps the cotton maintain continuous contact with the mesh surface. The dual-slot top airflow system directs air to the coil surface while working to reduce the risk of leakage.
The clamp-style build deck system of the Dead Rabbit M RTA features a postless design, allowing the mesh sheet to be placed into the connection points on both sides and secured with Phillips screws.
Curving the mesh sheet properly using the shaping tool included in the box helps the mesh surface make even contact with the cotton. Installation should be done carefully, as sharp bends or uneven surfaces can cause localized hotspots on the mesh.
The spring-loaded ceramic cotton bed located in the center of the deck pushes the cotton upward, helping it maintain constant contact with the mesh sheet.
It is important for the cotton to contact the mesh surface without gaps to reduce the risk of dry hits and localized burning. The cotton should not be placed too loosely, nor should it be compressed so tightly that it restricts liquid flow.
The dual-slot adjustable top airflow takes air from the top of the atomizer and directs it through internal channels to the mesh coil surface. This structure helps reduce the risk of liquid leakage compared to bottom-airflow atomizers.
The honeycomb-shaped air channels in the inner section aim to provide smoother DTL draws, dense vapor, and balanced flavor performance by ensuring air is distributed more evenly over the mesh surface.
The Dead Rabbit M RTA offers a 3ml liquid capacity when using the standard straight glass, and a 4.5ml capacity when the bubble glass included in the box is installed.
The quarter-turn opening top cap and large dual filling ports make refilling the atomizer quick and clean. Care should be taken not to spill liquid into the central airflow channel during filling.
Before use, check the wattage range specified on the mesh sheet or its packaging. Perform the first firing at low power and gradually increase the wattage.
Brand: Hellvape
Model: Dead Rabbit M RTA
Atomizer type: Rebuildable mesh tank atomizer
Vaping style: DTL
Base diameter: 25mm
Widest diameter: Approx. 26.5mm
Height: Approx. 46.5mm
Liquid capacity: 3ml straight glass / 4.5ml bubble glass
Filling system: Quarter-turn top-fill
Build deck: Postless clamp mesh deck
Configuration: Single mesh coil
Cotton support: Spring-loaded ceramic bed
Insulation: Heat-resistant PEEK insulator
Airflow: Adjustable dual-slot top airflow
Drip tip: Wide-bore 810 drip tip
Connection: Standard 510
Body material: Stainless steel
1 × Hellvape Dead Rabbit M RTA
2 × 0.15Ω SS316L mesh sheet
2 × 0.25Ω KA1 mesh sheet
1 × Multi-purpose mesh shaping tool
4 × Max Shoelace cotton
1 × 4.5ml spare bubble glass
1 × Spare accessories pack
1 × User manual
This product is not a classic tank using pre-built coils. It requires experience with mesh installation, wicking, resistance control, and battery safety.
The mesh sheet must be curved properly, and there should be no gaps between it and the ceramic cotton bed. If the mesh surface does not fully contact the cotton, localized heating and cotton burning may occur.
After installation, check the resistance value using a reliable ohm meter or a protected electronic mod. Do not fire if there is a short circuit, unstable resistance, or loose connection.
Before first use, fully saturate the cotton with e-liquid, fill the tank, and wait approximately 10–15 minutes before firing. Do not fire with dry cotton.
