The HellVape Dead Rabbit 4 RTA Pro is a rebuildable tank atomizer developed for dense vapor and robust flavor performance, featuring an expanded 13 mm dual coil deck, 48-hole air distribution, and top-to-bottom directed airflow.
The Dead Rabbit 4 RTA Pro is an enhanced version of HellVape's Dead Rabbit RTA platform, focused on dual coil performance. Its 26 mm stainless steel body offers a balanced usage with high-power dual-battery mod devices.
The approximately 12 mm workspace found in the Dead Rabbit 3 model has been expanded to 13 mm in the Pro version. This one-millimeter increase provides a more comfortable workspace for positioning large-diameter coils and placing cotton ends into the liquid channels.
The redesigned 48-hole deck directs air to the coil surfaces from multiple points. The wide air distribution helps use heat more evenly in dual coil setups, produces dense vapor, and clearly conveys the flavor.
The 13 mm wide workspace makes it easier to position two performance coils opposite and balanced to each other. The generous wicking area supports feeding with high VG e-liquids.
The 48 small air openings on the deck allow air to reach the coil surfaces from a wider area. This structure helps reduce air turbulence and creates a more balanced draw.
Air is taken from the upper section of the atomizer and directed through internal channels to the deck and coil surfaces. The top air intake helps reduce the risk of liquid leaking out compared to conventional RTA models with bottom air inlets.
The manufacturer introduces this system as leak-resistant. However, incorrect wicking, overfilling, a loose o-ring, or faulty setup can cause liquid leakage.
Sliding the top cap sideways opens the fill channel. This system allows quick and clean e-liquid refilling without removing the tank from the mod device.
The metal mesh around the vaporization chamber completes the visual design and helps provide additional physical protection to the inner section of the tank.
Pre-installed glass and package contents may vary depending on regional packaging. Some packages may include a 2 ml TPD glass, while others may come with a 3.5 ml straight glass pre-installed.
The Dead Rabbit 4 RTA Pro is not an atomizer that uses pre-made coil heads. The wires in the box must be installed onto the deck, resistance and short-circuit checks must be performed, and it must be wicked by the user.
When two 0.37Ω coils are connected in parallel, the total resistance can drop by about half. Since the actual resistance value will vary depending on coil leg length and setup, it must be checked via the mod device or Ohm meter before firing.
This model is a DL atomizer aimed at high vapor production. It is not recommended for use with high-nicotine Salt e-liquids. Undamaged, reliable high-discharge batteries with appropriate amperage ratings must be used.
No. This model is a rebuildable RTA with a dual coil deck structure. The parts coming out of the box are not pre-made coil heads, but pre-wrapped coil wires intended to be installed on the deck.
When two coils of equal resistance are connected in parallel, the theoretical total value can drop to around 0.18Ω–0.19Ω. The actual value seen after setup must always be checked via the mod device or Ohm meter.
Capacity varies depending on the glass used and regional packaging. The TPD glass offers 2 ml, the standard straight glass 3.5 ml, and the Bubble Glass approximately 5.5 ml capacity.
Top-to-bottom airflow is designed to reduce the risk of leakage. However, absolute leak-proof guarantees cannot be given on any RTA without proper wicking, o-ring checks, and correct filling.
No. Due to the wide 810 Drip Tip, dual coil deck, and high air volume, it is designed for direct lung usage producing dense vapor.
