Designed in Germany, the eXpromizer V5 is a rebuildable tank atomizer developed for tight and flavor-focused MTL use, featuring a single coil deck, top-to-bottom airflow, adjustable liquid control, and a sliding top-fill system.
The eXpromizer V5 is the fifth generation of the MTL RTA series developed by eXvape. It combines the characteristic knurled design lines of the V3 model with the liquid control and top-to-bottom airflow system used in the V4 model.
With a 23 mm diameter body and a height of 54 mm including the Drip Tip, it offers a more compact structure compared to previous generations. The stainless steel tank shield helps protect the Pyrex glass against external impacts while allowing the liquid level inside the tank to be visible.
The single coil build deck is designed for easy securing and wicking of MTL coils. The adjustable liquid control system helps regulate the amount of liquid reaching the cotton according to the viscosity of the e-liquid used.
Dual-Style Adjustable MTL Airflow
Six different openings located on one side of the airflow control ring allow the draw resistance to be adjusted between specific stages. Smaller openings can be used for a tighter MTL draw.
The wide opening on the other side of the airflow ring allows the air volume to be adjusted steplessly. Thus, a tighter or airier MTL draw can be created.
Air is taken from the upper section of the atomizer, carried down through side channels inside the body, and directed to the bottom surface of the coil. This design helps reduce the risk of liquid leaking out compared to conventional RTA models with bottom air inlets and helps create a balanced air distribution beneath the coil.
The liquid control allows the amount of e-liquid reaching the cotton to be adjusted according to the viscosity of the liquid used. Control can be reduced for thinner liquids and increased for denser liquids. The optimal setting may vary depending on the wire, cotton amount, and VG/PG ratio.
After loosening the threaded lock on the upper section, the fill cap is slid open sideways. Closing the liquid control before filling helps reduce the risk of the vaporization chamber flooding with excess liquid and causing gurgling.
The coil in the box is not a pre-made coil head. It is a pre-wrapped coil wire intended to be installed on the single coil deck and wicked by the user. Package contents may show minor variations depending on the production batch.
The eXpromizer V5 is not an atomizer that uses pre-made coil heads. Wire and cotton installation are done by the user. Resistance and short-circuit checks must be performed before firing, cotton must be completely saturated with liquid, and the safe amperage limits of the battery used must be taken into consideration.
Although top airflow helps reduce the risk of leakage, incorrect wicking, excessive liquid feeding, or leaving the liquid control open during filling can cause issues such as gurgling and spitting.
The manufacturer's official statement indicates that the product is designed in Germany. Therefore, the phrase "designed in Germany" should be used rather than "manufactured in Germany."
No. This model is a rebuildable RTA with a single coil deck structure. The pre-wrapped wire included in the box must be installed on the deck and wicked.
Yes. Closing the liquid control before filling reduces the risk of excessive liquid reaching the chamber and causing gurgling. The appropriate feeding setting should be reopened after filling.
The adjustable liquid control helps accommodate e-liquids with different viscosities. However, the proper liquid control and wicking setup should be adjusted according to the VG/PG ratio of the liquid used.
The V5 combines the design lines of the V3 with the top-to-bottom airflow and liquid control system of the V4. While retaining the same 2 ml capacity, it offers a more compact body and an improved sliding top-fill system.
