The HellVape MD RTA offers a customizable rebuildable atomizer experience ranging from a tight MTL draw to a looser RDL vape, thanks to its interchangeable rotating airflow disks, single coil build deck, and tank capacity ranging from 2 ml to 4 ml.
The HellVape MD RTA is a 24 mm diameter rebuildable tank atomizer developed for flavor-focused single coil use. Thanks to its spacious build deck, top-secured flat-head screws, and two wide cotton channels, it helps make coil placement and wicking much more convenient.
The most prominent feature of the model is the interchangeable rotating airflow disks placed in the center of the build deck. Different slot and multi-hole airflow outlet options allow air to be directed to the coil surface in various ways.
Combined with the external airflow control ring, these disks enable tight MTL draws, looser MTL, and restricted direct lung (RDL) vaping options. Thus, draw tightness, vapor volume, and flavor intensity can be adjusted to personal preference.
Interchangeable Rotating Airflow System
Narrower slot and multi-hole outlet options direct air onto the coil in a controlled manner, helping to create a tight or medium-tight MTL draw.
The disk option with a wider air outlet and the external air ring allow the draw to open up, offering higher air volume and denser vapor production.
The selected rotating disk directs air directly beneath the coil. Using the external airflow ring and internal disk together allows draw resistance to be adjusted precisely. For best results, the coil should be centered balanced over the chosen air outlet.
To fill the tank, first remove the 510 Drip Tip. Then slide the top cap in the marked direction to open the filling port. This system, which prevents the cap from sliding while the Drip Tip is attached, helps reduce the risk of accidental opening.
The 0.7Ω and 1.2Ω items inside the box are not pre-made coil heads. They are pre-wrapped coil wires that need to be mounted on the deck and wicked. Package contents may show minor variations depending on the production batch.
The HellVape MD RTA is not an atomizer that uses pre-made coil heads. Wire and cotton installation are done by the user. Resistance and short-circuit checks must be performed before firing, cotton must be completely saturated with liquid, and the safe amperage limits of the battery used must be taken into consideration.
In bottom-airflow RTA models, incorrect or insufficient wicking can cause liquid leaking, gurgling, or spitting into the mouth. It is important that the cotton ends seal the liquid channels without leaving gaps.
No. This model is a rebuildable RTA featuring a single coil deck structure. The pre-wrapped wires included in the box must be installed on the deck and wicked by the user.
While the airflow disks allow the draw to open up, the model's primary use case is MTL and RDL. It does not offer as wide a draw as high-power DL atomizers with very open airflow.
The pre-installed straight glass offers a 2 ml capacity. When using the Bubble Glass included in the box, the capacity increases to approximately 4 ml.
First, remove the 510 Drip Tip. Then slide the top cap in the marked direction to open the filling port. After filling is complete, close the cap and reattach the Drip Tip.
The amount of cotton must be sufficient and cover both liquid channels without leaving gaps. Loose wicking can cause over-feeding and liquid escaping through the bottom air channels.
